SEAL 30

Hardening treatment against dust.


One-component dissolved colourless polyurethane to harden and avoid dust in concrete floors. It is ideal for coloured concrete floors and it has waterproof properties which impede the soak of oils, greases, etc. the product makes a transparent and hard film which resists blows and abrasion perfectly. SEAL-30 is not destroyed by bad concrete and it has the mechanical and chemical properties of polyurethane.

Uses

In all kinds of industries, stores, car parks, etc. which need deep cleanings. SEAL-30 can be applied on surfaces made of fibrocement, wood, etc. It also allows converts a sliding surface into a non-slipping one through the addition of silica sand.

Surface preparation

The surface must be clean and dry and exempt of greases, oils and other pollutants. It is recommended to scrape off or to mill the surface (with a milling machine or a “scrapping” machine) to achieve an open pore surface in order to facilitate a good adherence of the product. It is also recommended to dilute the product with our product DILUYENTE Nº1 when applying the first coat.

Instructions for use

SEAL 30 can be applied with brush, paint roller, paintbrush or airless.
Apply the first coat diluted at 15% with our DILUYENTE Nº1. To apply the second coat it is important to adjust the viscosity with a maximum of 10%.
Maximum time between coats can not be longer than 24 hours. Two coats are always necessary. A third coat is recommended where there is a lot of traffic.

Consumption

Depending on the surface the consumption can range from 5-6 m² /kg per coat. It will be advisable to make a test to know the exact consumption.

Colours

Colourless

Packing and storing

SEAL-30 is supplied in hermetic barrels of 25 Kg., according to EC packing and storing directives for chemical products.

Hygiene and safety

See product label.

Specification

Density at 20ºC:1.0 +-0.03 g/ml
Viscosity (Copa Ford Nº4, 25ºC):15”
Dry extract:45.0 +-3.0 %.
Water percentage(Karl-Fischer) : 0.1%
Film aspect:bright.
Wear in Taber abraser (CS10, 1Kg. 100 revolutions):3-5mg.
Persoz hardness (45 micron film, 120 hours of drying):210”
Drying time:
Dry-to-touch:4 hours.
Total:24 hours.



Notes:

- La presente ficha técnica sirve, al igual que todas las demás recomendaciones e información técnica, únicamente para la descripción de las características del producto, forma de empleo y su aplicaciones. Los datos e informaciones reproducidas se basan en nuestros conocimientos técnicos obtenidos en bibliografia, en ensayos de laboratorio y en la práctica.
- Los datos sobre consumo y dosificación que figuran en esta ficha técnica se basan en nuestra propia experiencia, por lo que estos son susceptibles de variaciones debido a las diferentes condiciones de las obras. Los consumos y dosificaciones reales deberán determinarse en la obra mediante ensayos previos y son responsabilidad del cliente.
- Para un asesoramiento adicional, nuestro Departamento de Química Aplicada para la Construcción, está a su disposición.
- Otras aplicaciones del producto que no se ajusten a las indicadas, no serán de nuestra responsabilidad.
- Otorgamos garantía en caso de defectos en la calidad de fabricación de nuestros productos, quedando excluidas las reclamaciones adicionales, siendo de nuestra responsabilidad tan sólo la de reingresar el valor de la mercancía suministrada.
- Deben tenerse en cuenta las eventuales reservas correspondientes a patentes o derechos de terceros.
- La presente ficha técnica pierde su validez con la aplicación de una nueva edición.